LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Cherokee Trailhawk >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, HVAC >> Removal

Module, HVAC: Removal

WARNING:

Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the Integrated Center Stack (ICS). Refer to MODULE, INTEGRATED CENTER STACK (ICSM), REMOVAL .
    GC0156251Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the wire harness connectors (1) from the Heating, Ventilation and Air Conditioning (HVAC) module.
  4. Remove the fasteners (2) securing the HVAC module.
  5. Remove the HVAC module from the HVAC housing.
scientia non olet · About LEMON Manuals