Diagnostic Test
VERIFY THE DTC IS ACTIVE
NOTE:
This DTC must be active for the results of this test to be valid.
- Ignition on, engine not running.
- With the scan tool, read DTCs and record on vehicle work order.
- With the scan tool, erase DTCs.
- Start the engine and run for two minutes.
- Turn the steering wheel from stop to stop.
- With the scan tool, read EPS DTCs.
Is the DTC active at this time?
Yes
- Replace the Electric Power Steering (EPS) Module in accordance with Service Information. Refer to GEAR, REMOVAL .
- Perform the EPS VERIFICATION TEST. Refer to EPS VERIFICATION TEST .
No
- The condition or conditions that originally set this DTC are not present at this time. Using the appropriate SYSTEM WIRING DIAGRAMS as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension and repair as necessary. If no problems are found, test complete.
- Perform the EPS VERIFICATION TEST. Refer to EPS VERIFICATION TEST .