LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Cherokee High Altitude, Full Time T/Case Control >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (2.4L Engine (Service Information)) >> Lubrication >> Sensor, Oil Pressure >> Removal

Sensor, Oil Pressure: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
    GC0156354Courtesy of CHRYSLER GROUP, LLC
  4. Disengage the sensor harness retainer (5) from the engine block.
  5. Unlock and disconnect the oil pressure sensor electrical connector (4).
  6. Unscrew and remove the sensor (2) from the cylinder block.
scientia non olet · About LEMON Manuals