LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Cherokee High Altitude, Full Time T/Case Control >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Instrument Panel Cluster (IPC) >> Removal >> Instrument Panel Cluster

Instrument Panel Cluster

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the Instrument Panel Cluster (IPC) bezel. Refer to BEZEL, INSTRUMENT CLUSTER, REMOVAL .
  3. Disengage the two gap hider clips at the bottom of the instrument cluster.
    GC0159211Courtesy of CHRYSLER GROUP, LLC
  4. Remove the two upper (1) and the two lower (2) fasteners securing the IPC to the instrument panel.
  5. Pull the top of the IPC back and lift the IPC upward to remove.
    GC0187087Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the instrument panel wire harness connector (2) from the back of the IPC (1).
    GC0160111Courtesy of CHRYSLER GROUP, LLC
  7. Remove the IPC (1) from the vehicle.
scientia non olet · About LEMON Manuals