Module, Electric Park Brake (EPBM): Removal

Courtesy of CHRYSLER GROUP, LLC

1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
2. Remove the cargo load floor panel and left storage tray, if equipped. Refer to LOAD FLOOR, CARGO, REMOVAL .
3. Remove the left rear lower quarter trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL .
4. Disconnect the wire harness connector (1) from the Electric Park Brake (EPB) module (3).
5. Using a suitable tool, gently slide the retainer (2) from the stud.
6. Remove the fastener (4) and remove the EPB module (3).