LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Cherokee High Altitude, Automatic T/Case Control >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (3.2L Engine (Service Information)) >> Air Intake System >> Resonator, Air Cleaner >> Removal

Resonator, Air Cleaner: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
    GC0159742Courtesy of CHRYSLER GROUP, LLC
  2. Remove the engine cover (1) from the mounting posts (2).
    GC0186386Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the make-up air hose (3) from the air inlet tube.
  4. Loosen the clamps (1, 2) and remove the air inlet hose.
    GC0160169Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the harness connector (2) from the Inlet Air Temperature (IAT) sensor (3).
    GC0159897Courtesy of CHRYSLER GROUP, LLC
  6. Remove the vapor line retainer (4) from the resonator (1).
  7. Remove the push pin (3) that secures the resonator to the intake manifold.
  8. Pull the resonator straight up from the two locating pins on the right cylinder head cover. Disengage and remove the resonator from the throttle body inlet.
    NOTE:

    The Grommet on the rear attachment of the resonator may stay on engine. Ensure that the grommet is removed and installed onto the resonator.

scientia non olet · About LEMON Manuals