LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2020 >> Renegade Trailhawk >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (2.4L Engine (Service Information)) >> Engine Block >> Damper, Vibration >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.
GC0164247Courtesy of CHRYSLER GROUP, LLC
  1. Install the vibration damper onto the crankshaft (1c).
  2. Using the (special tool #9707, Holder, Vibration Damper) (1a), Install the vibration damper bolt (1b) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  3. Install the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL AND INSTALLATION .
  4. Install the right front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION .
  5. Install the right front tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
  6. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals