LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2020 >> Renegade Limited, FWD >> Repair and Diagnosis >> Engine Performance >> 1.3L Ignition System >> Sensor, Camshaft Position >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Install the CMP sensor with a NEW  O-ring and connect the wiring harness connector.
  2. Install the heat shield and securely tighten the bolt.
  3. Install the catalytic converter. Refer to CONVERTER, CATALYTIC, REMOVAL AND INSTALLATION .
  4. Connect the negative battery cable.
  5. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals