LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2020 >> Renegade High Altitude, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (2.4L Fuel System) >> Fuel Injection >> Sensor, Air Temperature, Intake >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION .
    GC0163254Courtesy of CHRYSLER GROUP, LLC
  2. Disconnect the electrical connector (1) from the intake air temperature sensor (2).
  3. Rotate the intake air temperature sensor 1/4 turn counter clockwise and remove the sensor from the clean air hose.
  4. The sensor O-ring seal can be reused if not damaged.
scientia non olet · About LEMON Manuals