LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2020 >> Grand Cherokee Trackhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Electronic Control Modules (Service Information)) >> Module, Fuel Pump Control >> Installation

Module, Fuel Pump Control: Installation

WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the fuel pump control modules in the mounting bracket.
  2. Install the fuel pump control module mounting nuts and tighten to the proper (Torque Specifications).
  3. Connect the fuel pump control module wire harness connector to the module.
  4. Install the rear carpet assembly. Refer to CARPET, FLOOR, INSTALLATION .
  5. Install the rear seat. Refer to SEAT, FRONT, INSTALLATION .
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals