LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2020 >> Gladiator Overland, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Electronic Control Modules (Service Information)) >> Module, Heated Seat (HSM) >> Removal

Module, Heated Seat (HSM): Removal

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Disable the airbag system before attempting any front seat diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

GC0144580Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the fasteners that secure the front passenger seat to the body and tip the seat rearward to gain access to the underneath of the seat. Refer to SEAT, FRONT, REMOVAL .
  3. Disconnect the electrical connectors (3) from the Heated Seat Module (HSM) (1).
  4. Disengage the retaining tab (5) that secures the rear of the HSM to the bracket (4).
  5. Disengage the two front retaining tabs (2) from the bracket and remove the HSM.
scientia non olet · About LEMON Manuals