LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2020 >> Gladiator Altitude, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Electronic Control Modules (Service Information)) >> Module, Drivetrain Control (DTCM) >> Removal

Module, Drivetrain Control (DTCM): Removal

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the cowl side trim panel. Refer to PANEL, COWL TRIM, REMOVAL .
    GC0095226Courtesy of CHRYSLER GROUP, LLC
  3. Pull back the drivers foot well carpet and position aside to access the Drivetrain Control Module (DTCM) (3).
  4. Loosen the mounting fastener (2) from mounting stud (6).
  5. Remove the mounting fastener (4) from mounting stud (5).
  6. Slide the DTCM (3) from the mounting stud (6) and remove from drivers side foot rest.
scientia non olet · About LEMON Manuals