LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2020 >> Gladiator Altitude, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Rear Suspension) >> Link, Compression >> Installation

Link, Compression: Installation

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the compression link in the vehicle.
    GC0170389Courtesy of CHRYSLER GROUP, LLC
  2. Install the compression link to crossmember bolt (2). Do not tighten bolt at this time. 
  3. Install the compression link to knuckle bolt (1). Do not tighten bolt at this time. 
    GC0170329Courtesy of CHRYSLER GROUP, LLC
  4. Install the lower shock absorber bolt (1). Do not tighten bolt at this time. 
  5. Install the tire and wheel assembly. Refer to INSTALLATION .
  6. Remove the support and lower the vehicle.
  7. Position the vehicle on an alignment rack/drive-on lift. Position the vehicle to access the compression link fasteners.
  8. Tighten the compression link bolts to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  9. Tighten the lower shock absorber bolt to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  10. Perform wheel alignment. Refer to WHEEL ALIGNMENT .
scientia non olet · About LEMON Manuals