LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2020 >> Gladiator Altitude, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Front Suspension & Wheel Alignment) >> Front >> Sensor, Active Damping >> Removal >> Front

Sensor, Active Damping: Removal: Front

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Removal process is the same for both sides of the vehicle.

GC0170152Courtesy of CHRYSLER GROUP, LLC
  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Release the terminal locking tab and disconnect the wiring harness connector (1).
  3. Remove the front Active Damping System (ADS) sensor bolt (3) and sensor (2) from the vehicle.
scientia non olet · About LEMON Manuals