Removal And Installation: RHD: Installation
- Position the Electric Hydraulic Power Steering (EHPS) pump (2) on the EHPS pump bracket.
- Install the three EHPS pump bracket nuts (1) and tighten to the proper specifications. Refer to TORQUE SPECIFICATIONS .
- Position the EHPS pump to the vehicle.
- Tighten the two power steering pump bracket frame bolts (1) to the proper specifications. Refer to TORQUE SPECIFICATIONS .
- Install the EHPS pressure line to the pump.NOTE:
Make sure the O-ring is clean and seats properly.
- Install the EHPS pump pressure line bolt (2) and tighten to the proper specifications. Refer to TORQUE SPECIFICATIONS .
- Connect the return line (3) to the EHPS pump and ensure the hose clamp is securely positioned.
- Connect the supply line (4) to the EHPS pump and ensure the hose clamp is securely positioned.
- Install the left front wheel house splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION
.
- Connect the two EHPS pump wire harness connectors (2) and secure the wiring harness routing clips in the EHPS pump.
- Remove the supports and lower the vehicle.
- Install the power distribution center. Refer to CENTER, POWER DISTRIBUTION (PDC), REMOVAL AND INSTALLATION .
- Connect the negative battery cable(s). Refer to BATTERY DISCONNECT AND CONNECTION .
- Refill the power steering fluid and bleed the system. Refer to POWER STEERING SYSTEM BLEEDING .