Diagnostic Test
WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
CHECK IF THE DTC IS ACTIVE
- Turn the ignition off and remove the key from the ignition.
- Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.
- Disarm the VTSS.
- With the scan tool, read ITM DTCs.
Does the scan tool display this DTC as active?
Yes
- Replace the Intrusion Transceiver Module in accordance with the Service Information. Refer to MODULE, INTRUSION, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- The condition or conditions that originally set this DTC are not present at this time. Using the appropriate SYSTEM WIRING DIAGRAMS as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .