LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2020 >> Gladiator Altitude, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Electronic Control Modules (Service Information)) >> Module, Tire Pressure Monitoring (TPM) >> Installation

Module, Tire Pressure Monitoring (TPM): Installation

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
GC0170346Courtesy of CHRYSLER GROUP, LLC
  1. Position the Tire Pressure Monitoring (TPM) module in the RH wheel well.
  2. Install the front TPM module nuts (2), then install the TPM module nuts (3) at the body flange.
  3. Connect the TPM module electrical connector (1).
  4. Install RH rear splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, INSTALLATION .
  5. Carry out one of the following to update the system for the new sensor ID:
    1. Using the TPM-RKE Analyzer 9936 with the Scan Tool, program the TPM Module with the new tire pressure sensor ID. This is part of the TPM Diagnostic Verification Test. Refer to STANDARD PROCEDURE - TPM VERIFICATION .
    2. The vehicle should remain stationary for at least 20 minutes. Drive the vehicle for a minimum of 20 minutes while maintaining a continuous speed above 24 km/h (15 mph). During this time, the system will recognize and add the new sensor ID.

      This is part of the TPM Diagnostic Verification Test. Refer to STANDARD PROCEDURE - TPM VERIFICATION .

scientia non olet · About LEMON Manuals