LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2020 >> Gladiator Altitude, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Electronic Control Modules (Service Information)) >> Module, Memory >> Installation

Module, Memory: Installation

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Depending on how equipped, more memory seat module electrical connectors may be present than shown in the illustration.

GC0144638Courtesy of CHRYSLER GROUP, LLC
  1. Position the Memory Seat Module (MSM) (2) to the bracket (4) and connect the wire harness connectors to the rear of the MSM.
    CAUTION:

    Properly align the Memory Seat Module (MSM) retaining tabs to the bracket, prior to engagement. Failure to follow these instructions may result damage to the MSM retaining tabs.

  2. Install the MSM into the bracket and engage the rear MSM retaining tabs to the bracket.
  3. Engage the front MSM retaining tabs (3 and 5) to the bracket by carefully pulling down on the front of the MSM.
  4. Connect the wire harness connectors (1) to the front of the MSM.
  5. Install the driver seat. Refer to SEAT, FRONT, INSTALLATION .
  6. Connect the negative cable to the battery. If equipped with an Intelligent Battery Sensor (IBS), reconnect the IBS connector.
  7. Perform the Power Seat System Verification test. Refer to POWER SEAT SYSTEM VERIFICATION TEST .
scientia non olet · About LEMON Manuals