LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2020 >> Gladiator Altitude, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Electronic Control Modules (Service Information)) >> Module, Intrusion Transceiver (ITM) >> Installation

Module, Intrusion Transceiver (ITM): Installation

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
GC0146812Courtesy of CHRYSLER GROUP, LLC
  1. Position the Intrusion Transceiver Module (ITM) (2) into the mount integral to the overhead console housing. Be certain that all of the latch features are fully engaged
  2. Connect the intrusion module sensor pigtail wire harness connector (1) to the ITM.
    GC0146811Courtesy of CHRYSLER GROUP, LLC
  3. Install the overhead console into the headliner. Refer to CONSOLE, OVERHEAD, INSTALLATION .
  4. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals