LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2020 >> Gladiator Altitude, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Electronic Control Modules (Service Information)) >> Module, Drivetrain Control (DTCM) >> Installation

Module, Drivetrain Control (DTCM): Installation

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
GC0095226Courtesy of CHRYSLER GROUP, LLC
  1. Slide the Drive Train Control Module (3) on the mounting stud (6) and over mounting stud (5).
  2. Install mounting fasteners (2 and 4) and tighten them to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  3. Secure the drivers footwell carpet back to its installed position.
  4. Install the cowl side trim panel. Refer to PANEL, COWL TRIM, INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals