LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2020 >> Gladiator Altitude, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Ignition System (Service Information)) >> Solenoid, Variable Valve Timing >> Removal >> Right

Solenoid, Variable Valve Timing: Removal: Right

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
    GC0144028Courtesy of CHRYSLER GROUP, LLC
  2. Remove the engine cover (1).
  3. Remove the air cleaner body. Refer to REMOVAL .
    GC0144211Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Mark the Variable Valve Timing Solenoid (VVTS) connectors (1) with a paint pen or equivalent so that they may be reinstalled in their original locations.

  4. Mark the intake VVTS (2) and the exhaust VVTS solenoid (4) with a paint pen or equivalent so that they may be reinstalled in their original locations.
  5. Disconnect the VVTS wire harness connector (1).
  6. Remove bolts (3) and pull the VVTS from the cylinder head cover.
    GC0144209Courtesy of CHRYSLER GROUP, LLC
  7. The seal (1) can be reused if not damaged.
scientia non olet · About LEMON Manuals