Removal And Installation: Installation
NOTE:
The following procedure applies only to vehicles manufactured for the NAFTA markets.
- Reach under the rear edge of the front seat cushion to connect the seat wire harness connector (2) to the STPS (3) connector receptacle. Be certain that the latch on the connector is fully engaged.
- Align the open end of the STPS mounting slot (1) to the blade of the STPS bracket located on the inboard side near the rear of one of the upper seat tracks.
- Push the STPS firmly onto the bracket until the latch (1) feature snaps into place with an audible click.
- Do not connect the negative battery cable at this time. The Supplemental Restraint System (SRS) Verification Test procedure should be performed following service of any SRS component. Refer to SUPPLEMENTAL RESTRAINT SYSTEM VERIFICATION TEST .