LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade Trailhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 1308 (Electronic Control Modules (Service Information)) >> Module, Forward Facing Camera (FFCM) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Ensure that both inside and outside of the windshield in the area of the Forward Facing Camera (FFC) is clean of dirt, dust, or finger prints prior to installation.

  1. Install the FFC to the bracket on the windshield. Position the FFC to the bracket attachment point making sure that the alignment tabs are proper and set the FFC in place until the bracket locks engage.
  2. Connect the wire harness connector to the back of the FFC.
  3. Assemble the rear view mirror covers into place. Refer to MIRROR, REARVIEW, INSTALLATION .
  4. Connect the negative battery cable.
  5. Perform module programming. Refer to MODULE, FORWARD FACING CAMERA (FFCM), MODULE PROGRAMMING .
    NOTE:

    If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.

scientia non olet · About LEMON Manuals