TMAP Sensor (CAC Temp)

REMOVAL 

1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
2. Remove the engine cover. Refer to REMOVAL AND INSTALLATION
3. Remove the air cleaner body. Refer to REMOVAL AND INSTALLATION

   Courtesy of CHRYSLER GROUP, LLC

4. Unlock and disconnect the wire harness connector from the intake manifold pressure and temperature sensor (1).

   Courtesy of CHRYSLER GROUP, LLC

5. Remove the screw (1) and the intake manifold pressure and temperature sensor (1).

INSTALLATION 

1. Install the intake manifold pressure and temperature sensor and securely tighten the retaining screw.
2. Connect and lock the wire harness connector to the intake manifold pressure and temperature sensor.
3. Install the air cleaner body. Refer to REMOVAL AND INSTALLATION
4. Install the engine cover. Refer to REMOVAL AND INSTALLATION
5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.