Sensor, Fuel Pressure: Installation
WARNING: This page is about a different car, the 2017 RAM ProMaster 3500, 2017 RAM ProMaster 2500, and 2017 RAM ProMaster 1500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Diesel fuel is under extreme pressure in the high pressure side of the fuel injection system between the fuel injectors and the high pressure fuel pump. This may be as high as 1800 bar (26, 106 psi.). Use extreme caution when inspecting for leaks in the high pressure side of the fuel injection system. Fuel under this amount of pressure can penetrate skin causing personal injury or death. Inspect for high pressure fuel leaks with a sheet of cardboard. Wear safety goggles and adequate protective clothing when servicing the high pressure side of the fuel system.
- Install the fuel pressure sensor (1) and tighten to 70 N.m (52 ft. lbs.).
- Connect the fuel pressure sensor wire harness connector (1).
- Install the engine cover. Refer to COVER, ENGINE, INSTALLATION .
- Connect the negative battery cable.