Outer Tie Rod End

Courtesy of CHRYSLER GROUP, LLC

NOTE:

Do not twist the boot at anytime during removal or installation.

NOTE:

Make sure jam nut (3) is installed on inner tie rod end (4) before the outer tie rod end (2) is installed.

Thread the outer tie rod end (3) onto the inner tie rod, to it's original position.
Install the outer tie rod end (3) into the steering knuckle, install the nut and tighten to 95 N.m (70 ft. lbs.).
Set wheel toe pattern. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
Tighten the jam nut (4) to 75 N.m (55 ft. lbs.).