LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Grand Cherokee Trackhawk >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Instrument Panel Cluster (IPC) >> Removal >> Cluster Assembly

Cluster Assembly

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Position the steering column to its lowest position.
  3. Using a trim tool, release the clips and position the steering column seal back.
    GC0158338Courtesy of CHRYSLER GROUP, LLC
  4. Remove the fasteners (2&3) that secure the instrument cluster and bezel (1) assembly to the instrument panel.
  5. Pull the top of the instrument cluster back and lift the instrument cluster upward to remove.
    GC0158390Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the instrument cluster wire harness connector (1) from the connector receptacles on the back of the cluster housing.
  7. Remove the instrument cluster from the vehicle.
scientia non olet · About LEMON Manuals