Module, Power Liftgate Control (PLGM): Removal

Courtesy of CHRYSLER GROUP, LLC

1. Disconnect and isolate the battery negative cable.
2. Move the quarter trim panel from the lower left inner D-pillar (1) far enough to access the Power LiftGate Module (PLGM) (2). Refer to PANEL, QUARTER TRIM, REMOVAL .
3. Disconnect the two body wire harness (3) connectors from the PLGM connector receptacles.
4. Depress the latch feature integral to the upper end of the PLGM housing and pull the top of the PLGM away from the lower left inner D-pillar.
5. Disengage the two tabs integral to the lower end of the PLGM housing from the slots in the lower left inner D-pillar.
6. Remove the PLGM from the vehicle.