Module, Keyless Ignition Node (Kin): Installation

Courtesy of CHRYSLER GROUP, LLC

1. Install the two screws (1) securing the KIN module to the bezel.

   Courtesy of CHRYSLER GROUP, LLC

2. Connect the wire harness connector (1) for the Keyless Ignition Node (KIN) module.

   Courtesy of CHRYSLER GROUP, LLC

3. Install the bezel to the dashboard cover then install two screws (1) that secure the bezel to the dashboard cover.

   Courtesy of CHRYSLER GROUP, LLC

4. Place the steering column gap hider back to its installed position, engaging all the snap clips.
5. Install the instrument panel center bezel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, INSTALLATION .
6. If the KIN is being replaced, perform the RFHM verification test. Refer to RADIO FREQUENCY HUB (RF HUB) VERIFICATION TEST .