Module, Adaptive Cruise Control (Acc): Removal: Notes

Disconnect and isolate the battery negative cable.
Remove the front skid plate and air dam. Refer to PLATE, SKID, TRANSFER CASE, REMOVAL .
Disconnect the wire harness connector from the ACC module.
Remove the ACC module bracket fasteners.
Remove the ACC module with bracket from the vehicle.
NOTE:
The three molded plastic ball socket clips in the ACC module mounting bracket MUST be removed, discarded and replaced with new ball socket clips any time the module is removed from the bracket.
Remove the three molded plastic ball socket clips from the back side of the ACC module mounting bracket and discard. The clips are removed by rotating them counterclockwise.