Diagnostic Test

VERIFY THE DTC IS ACTIVE
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. With the scan tool, read the DTCs in the ASCM.
  Is the DTC active at this time?
  
  Yes
  - Go To 2
  No
  - Go To 3
AIR SUSPENSION VALVE BLOCK
1. Turn the ignition off.
2. Disconnect the ASCM C2 harness connector.
3. Measure the resistance between (Y30) 12 Volt Power Supply circuit and the (Y35) Ambient Valve Control circuit at the ASCM C2 harness connector.
  Is the resistance below 30 Ohms?
  
  Yes
  - Replace the Air Suspension Valve Block in accordance with the Service Information. Refer to VALVE BLOCK, COMPRESSOR ASSEMBLY, REMOVAL .
    NOTE:
    The Valve block (Solenoid) and Compressor are Serviceable separately. Replace the Valve Block only.
  - Perform the ASCM VERIFICATION TEST. Refer to ASCM VERIFICATION TEST .
  No
  - Replace the Air Suspension Control Module (ASCM) in accordance with the Service Information. Refer to MODULE, AIR SUSPENSION CONTROL (ASCM), REMOVAL .
  - Perform the ASCM VERIFICATION TEST. Refer to ASCM VERIFICATION TEST .
INTERMITTENT WIRING AND CONNECTORS
1. Using the wiring diagram/schematic as a guide, inspect the wiring harness and connectors.
2. Wiggle test the wiring harness and connectors while monitoring the scan tool data relative to this circuit.
3. Look for the data to change or for the DTC to reset during the wiggle test.
4. While monitoring the scan tool data relative to this circuit, move the selector switch to each position several times.
5. Look for the data to change other than as expected or for the DTC to reset.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the ASCM VERIFICATION TEST. Refer to ASCM VERIFICATION TEST .
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time.