Stabilizer Bar, Front: Installation
WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Ensure that the stabilizer link nuts are equipped with an encapsulated washer nut assembly upon installation.
- Position the stabilizer bar (8) to the vehicle.
- Install the stabilizer bushing clamps and tighten the two bolts on each side to 122 N.m (90 ft. lbs.).
- Position the stabilizer link (6) to the stabilizer bar (5), install the nut (4) and tighten to 115 N.m (85 ft. lbs.).
- Install the front skid plate. Refer to PLATE, SKID, TRANSFER CASE, INSTALLATION .
- Remove the supports and lower the vehicle.