LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Grand Cherokee Laredo, AWD, Automatic T/Case Control >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Starting System (Service Information)) >> Starter >> Installation >> 6.4L

Section 32 (Starting System (Service Information)): Starter: Installation: 6.4L

WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0104231Courtesy of CHRYSLER GROUP, LLC
  1. Install the starter (1) and tighten the fasteners (2) to the proper specification. Refer to TORQUE SPECIFICATION .
  2. Connect the starter solenoid wire harness connector.
  3. Install the battery cable and tighten the nut to the proper specification. Refer to TORQUE SPECIFICATION .
  4. Install the starter heat shield from the rear of the vehicle.
  5. Install the bolt and nuts securing the starter heat shield and tighten to the proper specification. Refer to TORQUE SPECIFICATION .
  6. Install the front driveshaft. Refer to INSTALLATION .
  7. Install the catalytic converter. Refer to 5.7L/6.4L .
  8. Install the front suspension skid plate. Refer to INSTALLATION .
  9. Connect the negative battery cable.
scientia non olet · About LEMON Manuals