Diagnosis And Testing
- Remove the power mirror switch.
- Disconnect the wire harness connector from the switch.
- Using an ohmmeter, test for continuity between the terminals of the switch.
- If results shown in the table are not obtained, replace the switch.
POWER MIRROR SWITCH TEST
| SWITCH POSITION | CONTINUITY BETWEEN PINS |
|---|---|
| MIRROR SELECT SWITCH IN "LEFT" POSITION | |
| UP | 6-16 |
| 15-13 | |
| DOWN | 8-16 |
| 15-13 | |
| LEFT | 6-16 |
| 15-13 | |
| RIGHT | 8-13 |
| 15-16 | |
| MIRROR SELECT SWITCH IN "RIGHT" POSITION | |
| UP | 14-16 |
| 17-13 | |
| DOWN | 14-13 |
| 17-16 | |
| LEFT | 7-16 |
| 14-13 | |
| RIGHT | 7-13 |
| 14-16 |
DRIVER POWER FOLDING MIRROR
| CLOSING | 11-13 |
| 12-16 |
PASSENGER POWER FOLDING MIRROR
| CLOSING | 1-13 |
| 10-16 |