LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Compass Trailhawk >> Repair and Diagnosis (Single Page) >> Transmission >> Transfer Case >> Power Transfer Unit (Service Information) >> Switch, Transfer Case >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Inspect the Power Transfer Unit (PTU) switch for damage.
  2. Install the PTU switch into the media hub, verifying the retaining clips are properly seated.
  3. Connect the PTU switch wire harness connector.
  4. Install the media hub. Refer to INSTALLATION
  5. Install the floor console. Refer to INSTALLATION .
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
scientia non olet · About LEMON Manuals