LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Compass Trailhawk >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Trailer Tow (TTM) >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Position the TTM on to the mounting bracket and install the four mounting bolts and tighten securely.
  2. Position the TTM in the vehicle.
  3. Connect the two TTM wire harness connectors.
  4. Engage the retaining clip securing the TTM to the body.
  5. Install the left rear storage tub.
  6. Connect the negative battery cable.
NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.

scientia non olet · About LEMON Manuals