LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Compass Trailhawk >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Electronic Control Modules (Service Information) >> Module, Power Liftgate Control (PLGM) >> Removal And Installation >> Installation

Removal And Installation: Installation

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.

GC0179093Courtesy of CHRYSLER GROUP, LLC
  1. Install the PLGM (2) into the vehicle. Be sure that the module housing latch (1) is fully engaged. 
  2. Connect the two PLGM wiring harness connectors (3).
  3. Install the left quarter trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
  4. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
  5. Perform the power liftgate teach procedure. Refer to POWER LIFTGATE LEARN CYCLE .
scientia non olet · About LEMON Manuals