LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Cherokee Trailhawk, 2.0L Eng VIN N >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Automatic Transmission (Service Information) >> Cover >> Removal

Automatic Transmission (Service Information): Cover: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. If equipped with a diesel engine, remove the left side Charge Air Cooler (CAC) hose. Refer to COOLER AND HOSES, CHARGE AIR, REMOVAL .
  3. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  4. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
  5. Remove the drain plug and allow the fluid to drain from the transmission.
  6. Install the drain plug and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
    GC0159235Courtesy of CHRYSLER GROUP, LLC
  7. Rotate the lock lever (1) counterclockwise on the transmission wire harness connector.
  8. Disengage the transmission wire harness connector from the socket on the transmission pan.
    GC0159610Courtesy of CHRYSLER GROUP, LLC
  9. Using a suitable pry tool, remove the clip (2) holding the wire transmission harness connector socket (1) in the valve body cover.
  10. Press the transmission wire harness connector socket inside the valve body cover.
    GC0160006Courtesy of CHRYSLER GROUP, LLC
  11. Remove the bolts (1) holding the valve body cover to the transmission.
  12. Remove the valve body cover from the transmission housing.
scientia non olet · About LEMON Manuals