Diagnostic Test

CHECK FOR AN ACTIVE CONDITION 

1. Turn the ignition on.
2. Read and record all DTCs.
3. With the scan tool, erase Transmission Control Module (TCM) Diagnostic Trouble Codes (DTCs).
4. Raise the vehicle on the hoist.
5. Start the Engine.
6. With the scan tool, monitor the Input Speed Sensor rpm.
7. Firmly apply the brake pedal and place the gear selector in Drive.
   WARNING:

   To avoid personal injury or death, keep hands and feet clear of rotating wheels.

8. Release the brakes and raise the engine speed to allow the Transmission to perform a 2-3 and 3-4 upshift.

   Did the Input Speed Sensor display an engine speed above 7, 700 rpm?

   Yes 

   • Remove the Transmission Oil Pan and inspect for excessive debris such as clutch friction material or metal contamination. Repair Transmission Internal components as necessary.
   • Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST .

   No 

   • Using the schematics as a guide, check the Transmission Control Module (TCM) connector terminals for corrosion, damage, and pushed out terminals. Pay particular attention to the power and ground circuits. If no problems are found, replace and program the TCM in accordance with the Service Information. Refer to MODULE, TRANSMISSION CONTROL (TCM), REMOVAL AND INSTALLATION .
   • Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST .