Knuckle, Steering: Installation
- Install the knuckle to the ball joint studs.
- Install the upper ball joint nut and cotter pin. Tighten to 95 N.m (70 ft.lbs)
- Install the lower ball joint nut and cotter pin. Tighten to 95 N.m (70 ft.lbs)
- Install the wheel speed sensor (1) through the hole in the brake shield (2).
- Install the axle shaft nut (if equipped). Tighten to 136 N.m (100 ft.lbs).
- Install the wheel speed sensor (1) in the hub/bearing and tighten the bolt (2) to 4-6 N.m (34-50 in. lbs.).
- Install the disc brake rotor (3).
- Install the disc brake caliper (4) and tighten the caliper adaptor mounting bolts (3) to 163 N.m (120 ft.lbs)
- Install the drag link to the knuckle and install the mounting nut. Tighten to 74 N.m (55 ft-lbs). Right side only.
- Install the drag link to the knuckle and install the mounting nut. Tighten to 74 N.m (55 ft-lbs).
- Install the tire and wheel assembly.
- Remove the support and lower the vehicle.