LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Trackhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 400 (Electronic Control Modules (Service Information)) >> Module, Active Noise Cancellation (ANC) >> Removal >> Module Removal

Module Removal

WARNING: This page is about a different car, the 2016 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

This procedure is for Alpine audio system. For all other audio systems, refer to AMPLIFIER, REMOVAL .

Fig 1: Fasteners, Wire Harness Connectors & ANC Module Bracket
GC0172171Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the right quarter trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL .
  3. Remove the subwoofer. Refer to SPEAKER, REMOVAL .
  4. Disconnect the two wire harness connectors (3) from the Active Noise Cancellation (ANC).
  5. Remove the fasteners (1), (4) and remove the ANC module (2).
  6. Remove the retainers from the ANC module bracket (2).
scientia non olet · About LEMON Manuals