LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Trackhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Electronic Control Modules (Service Information)) >> Module, A/C And Heater >> Removal >> Removal

Module, A/C And Heater: Removal: Removal

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

Fig 1: Four Screws, A/C Heater Module & Instrument Panel Support
GC0147666Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the center bezel from the instrument panel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL .
  3. Remove the four screws (1 and 3) that secure the A/C heater module (2) to the instrument panel support (4).
    Fig 2: Two Wire Harness Connectors, A/C Heater Module & Instrument Panel Support
    GC0147665Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the two wire harness connectors (2) and remove the A/C heater module (1) from the instrument panel support (3).
scientia non olet · About LEMON Manuals