LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Trackhawk >> Repair and Diagnosis (Single Page) >> Electrical >> Starter >> Starting System (Service Information) >> Relay, Power Control >> Installation

Relay, Power Control: Installation

GC0175256Courtesy of CHRYSLER GROUP, LLC
  1. Using two nuts, install the Power Control Relay (2) to the PCR bracket (1).
    GC0175214Courtesy of CHRYSLER GROUP, LLC
  2. Connect and secure the eyelet terminals (1) to the PCR using two nuts (3).
  3. Connect the wire harness connector (2) to the PCR.
    GC0175247Courtesy of CHRYSLER GROUP, LLC
  4. Inster the PCR cover (1) to the PCR.
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals