LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Altitude, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 400 (Electronic Control Modules (Service Information)) >> Module, Adaptive Cruise Control >> Removal >> Removal

Module, Adaptive Cruise Control: Removal: Removal

WARNING: This page is about a different car, the 2016 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the front skid plate and air dam. Refer to PLATE, SKID, FRONT, REMOVAL .
  3. Disconnect the wire harness connector from the ACC module.
  4. Remove the ACC module bracket fasteners.
  5. Remove the ACC module with bracket from the vehicle.
    NOTE:

    The three molded plastic ball socket clips in the ACC module mounting bracket MUST be removed, discarded and replaced with new ball socket clips any time the module is removed from the bracket.

  6. Remove the three molded plastic ball socket clips from the back side of the ACC module mounting bracket and discard. The clips are removed by rotating them counterclockwise.
scientia non olet · About LEMON Manuals