LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Compass Trailhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Starting System (Service Information)) >> Sensor, Neutral Position >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2019 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

LHD shown in illustration, RHD similar.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the floor console trim. Refer to CONSOLE, FLOOR, REMOVAL AND INSTALLATION .
    GC0165914Courtesy of CHRYSLER GROUP, LLC
  3. Working in front of the transmission shifter control (1a), disconnect the neutral position sensor (1c) wire harness connector (1b).
  4. Release the retainers (2a) and remove the sensor (1c) by lifting. If necessary, insert a suitable tool under the bottom of the sensor and apply light pressure to disengage the sensor from the seat.
scientia non olet · About LEMON Manuals