Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read ORC DTCs and record on the repair order.
2. Record the Environmental Data.
3. With the scan tool, erase DTCs.
4. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
5. With the scan tool, read ORC DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST .
CHECK THE OCCUPANT CLASSIFICATION MODULE (OCM) FOR FAULTS
1. Using the scan tool, determine if any OCM faults are present.
  Are there any OCM DTCs present?
  
  Yes
  - Repair any Occupant Classification Module faults.
  - Perform the OCCUPANT CLASSIFICATION MODULE (OCM) VERIFICATION TEST. Refer to OCCUPANT CLASSIFICATION MODULE (OCM) VERIFICATION TEST .
  No
  - Replace the OCCUPANT CLASSIFICATION MODULE (OCM). Refer to MODULE, OCCUPANT CLASSIFICATION (OCM), REMOVAL AND INSTALLATION .
  - Perform the OCCUPANT CLASSIFICATION MODULE (OCM) VERIFICATION TEST. Refer to OCCUPANT CLASSIFICATION MODULE (OCM) VERIFICATION TEST .
  - Go To 3
RECHECK FOR AN ACTIVE DTC IN THE OCCUPANT RESTRAINT CONTROLLER
1. Using the scan tool, clear and retest for an active B00A0-81 in the ORC.
  Is the DTC still active?
  
  Yes
  
  WARNING:
  If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.
  - Replace the Occupant Restraint Controller (ORC) in accordance with Service Information. Refer to MODULE, OCCUPANT RESTRAINT (ORC), REMOVAL AND INSTALLATION .
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
  No
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .