Lock Housing, Steering Column: Removal

Courtesy of CHRYSLER GROUP, LLC

Access and remove the Steering Column Control Module (SCCM) (3) from the steering column (2). Refer to CLOCKSPRING, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Remove the screw (1) fastening the SKREEM/WCM (2) to the lock cylinder housing (3).
Unhook the SKREEM/WCM (2) retainer fingers from the lock cylinder housing (3) and remove it.

Courtesy of CHRYSLER GROUP, LLC
Insert the key (2) and turn the key cylinder (3) to the RUN position.
Insert an appropriate tool into the slot (1) formed into the lock cylinder housing depressing the key cylinder retaining tab.
Pull the key cylinder and key straight out of the lock cylinder housing as one unit.

Courtesy of CHRYSLER GROUP, LLC
Using a Tamper-Proof Torx® Plus (five point) 30 bit, remove the two screws (1) fastening the lock cylinder housing (2) to the column.
Remove the lock cylinder housing from the steering column.

Courtesy of CHRYSLER GROUP, LLC
Remove the ignition module (2) mounting screw (1).

Courtesy of CHRYSLER GROUP, LLC
Pull the module (1) straight out and off the retaining tabs (2) located on the lock cylinder housing.