LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System >> Fuel Injection, Diesel >> Sensor, Crankshaft Position >> Installation

Sensor, Crankshaft Position: Installation

GC0085650Courtesy of CHRYSLER GROUP, LLC
CAUTION:

Before tightening the CKP sensor mounting bolt, be sure the sensor is completely flush to the cylinder block. If the CKP sensor is not flush, damage to the sensor mounting tang may result.

  1. Install the Crankshaft Position Sensor (CKP) sensor (4) and tighten the bolt (3) to 11 N.m (97 in. lbs.).
  2. Connect the CKP sensor wire harness connector (2).
  3. Install CKP access cover and tighten the bolts to 15 N.m (133 in. lbs.).
  4. Remove support and lower the vehicle.
  5. Connect the negative battery cable.
scientia non olet · About LEMON Manuals