Navigation/Telecommunication (Service Information): Microphone: Removal

Courtesy of CHRYSLER GROUP, LLC

1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
2. Remove the upper trim from the driver side A-pillar. Refer to PANEL, A-PILLAR TRIM, REMOVAL .
3. Disconnect the microphone pigtail wire harness connector (1) from the instrument panel wire harness connector (2).

   Courtesy of CHRYSLER GROUP, LLC

4. Remove the microphone (2) from the receptacle on the back side of the upper A-pillar trim (3) by carefully pushing in the latch tabs (1) on each side of the microphone and pulling the microphone out of the receptacle.