LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Rubicon, Automatic Trans >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Front Suspension & Wheel Alignment >> Front >> Stabilizer Bar, Front >> Installation >> Stabilizer Bar

Stabilizer Bar

GC0130310Courtesy of CHRYSLER GROUP, LLC
  1. Install the stabilizer bar (1) to the vehicle.
    NOTE:

    Stabilizer bar link to axle bolt should be tightened with vehicle sitting on its tires

  2. Install the right side stabilizer bar bracket bolts (3) to the frame. Tighten to the proper torque. Refer to TORQUE SPECIFICATIONS .
  3. Install the left side stabilizer bar bracket bolts (3) to the frame. Tighten to the proper torque. Refer to TORQUE SPECIFICATIONS .
  4. Install the splash shield.
    GC0130328Courtesy of CHRYSLER GROUP, LLC
  5. Install the right upper stabilizer bar link nut (2) to the stabilizer bar. Tighten to the proper torque. Refer to TORQUE SPECIFICATIONS .
    GC0130319Courtesy of CHRYSLER GROUP, LLC
  6. Install the left upper stabilizer bar link nut (1) to the stabilizer bar. Tighten to the proper torque. Refer to TORQUE SPECIFICATIONS .
  7. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals